| * 1: |
As for the TS-570CS/SG and the TS-870CS for PC command
restriction when " the frequency modification time in section definition memory
" and " frequency of standard memory variable it does temporarily ", unless
it is after the maximum of 1.5 seconds, the linear amplifier cannot detect the frequency
modification of the transceiver. |
| * 2: |
As for this type for PC command restriction, it cannot
know the transmission frequency of the transceiver from the linear amplifier. The use to
which sending and receiving frequency does not agree (split and the like) because it
cannot correspond, it cannot do frequency tracking operation. |
| * 3: |
When operating automatic, it does the mode of the
transceiver in command from the linear amplifier in the FSK. When " FSK monitor
" function TURNS ON, there are times when monitor sound is outputted while tuning. |
| * 4: |
After the auto-tuning operation ending because mode it
becomes all FSK modes regardless of the mode before the operating, please reset to
original mode. |
| * 5: |
Because in these types transmission power variable it
is not possible in command, to do, please set the output power which is necessary when
tuning by hand. |
| * 6: |
As for the TS-950SD/SDX because it does not have the
external AT connector, this function does not operate. |
| * 7: |
The IF-232c is used for exchanging the mode change and
the command at the time of the band selection. |
| * 8: |
Operation manual operation (as a general linear
amplifier), the above-mentioned object type it corresponds entirely. In this case, the
interface IF -232c becomes unnecessary even in the type of note 7. |
.gif){kind=spacer}
