568,000 Yen recommended retail price (classified by tax) The front (enlargement: 112k) Rear (enlargement: 165k) Main rating In connection with the Kenwood make transceiver being attached

* When each picture is clicked, it expands.

	You adopt the removal unrestricted operation panel. Adjusting to the station configuration, installation of vertical ranging * horizontal ranging is possible. In addition, if the separate cable of attachment (the 2m) you use, as for the substance as for the foot and the panel also installation of the separate constitution, on the desk is possible.		Vertical ranging		Horizontal ranging		Separate

In power amplifier unit, the RF power MOS FET of high resisting pressure (the 2SK410) 4 the broadband amplifier which is used 4 circuit mounting. In addition, in the output circuit of the power amplifier the Single Ended Push-Pull which breaks down the fault of the load push pull circuit due to transformer coupling scheme (the SEPP) you adopt the circuit. The IMD quality which with output and the former system which is room was not obtained from these, is superior was actualized.

Element constant of the matching circuit it loads the antenna tuner of the instantaneous change type which variable is done in binary due to CPU control. You adopt the low-pass filter type circuit, full cover to the 6m band from the HF band. In addition, the adjustable data of each antenna is automatically remembered in memory of large capacity, adjustment of each antenna is reproduced instantaneously. (Being independence, also use is possible)

5 antennas and 2 transceivers connected possibility. Being linked with the band which is selected, you adopt the automatic antenna switch which automatically selects the antenna. In addition, being independence, also use being possible, connected mode is a method of 3 sorts. Connected mode 1 Connected mode 2 Transceiver Antenna INPUT A A-1/A-2/A-3/A-4 INPUT B ANT B Transceiver Antenna INPUT A A-1/A-2/A-3/A-4 INPUT B Connected mode 3 Transceiver Antenna INPUT A A-1/A-2/A-3/A-4

- The instantaneous largest power source output 3.2kW (at the time of the AC200V) you adopt the PFC on-board high efficiency switching power supply which is pulled out. - Full break-in correspondence. - You adopt the abundant protection circuit which protects the circuit from the overdrive and output load abnormality et cetera. - It corresponds to the wide-ranging AC input power source voltage of the AC100V - the 240V. - The automatic power ON/OFF function which is linked with the power source ON/OFF operation of the transceiver. - Frequency tracking of the Kenwood make transceiver, the interface function where the automatic bandswitching, automatic antenna tuner setting and power on/off switching from transceiver are possible. * Automatic operation and the like differs depending upon the transceiver which you use. Details the corresponding chart viewing.

Note: AltaVista translations are "as-is". No responsibility is assumed for accuracy or content.

Updated 2001/08/30 by Webmaster (C) 2001 Kenwood Corporation